Audiovox CCS100 Information

Cable and Connector Pinouts

Servo Unit

Pin	Color	Description
1	Brown	Switched +12VDC
2	Grey	Speed Sensor (Not used on motorcycles)
3	Red	Constant +12VDC*
4	Purple	Brake (Apply +12V when braking)
5		N/C
6	Yellow	Resume
7		N/C
8	Green	Set
9	Black	Ground
10	Blue	Tachometer

*The installation manual contradicts itself on this line. One diagram refers to it as "Brake 1" and another says it should be connected to the side of the brake light switch fed by the battery. Most installations seem to simply connect it to the same source as the brown wire.

Control Pad

Color	Label	Description
Red	IGN	Switched +12VDC
Brown	ON	On Button (Shorts to IGN when closed)
Yellow	RES	Resume Button (Shorts to IGN when closed)
Grey	PARK	+12V for Backlighting
Green	SET	Set Button (Shorts to IGN when closed)
Black	GRD	Ground

Servo Unit Programming

Switch Settings

Pulses Per Minute (SW1/SW2)

• 2,000 - OFF/OFF
• 4,000 - ON/OFF
• 5,000 - OFF/ON
• 8,000 - ON/ON

Speed Signal (SW3)

• Tach Only - OFF
• Tach and VSS - ON

Sensitivity (SW4/SW5)

• Low (High power-to-weight) - ON/OFF
• Medium (Most vehicles) - OFF/OFF
• High (Low power-to-weight) - OFF/ON

Control Switch (SW6)

• Normally Closed - OFF
• Normally Open - OFF

Tach Source (SW7)

• ECM - OFF
• Coil - ON

Transmission Select (Jumper)

• Automatic - Closed
• Manual - Open

Preferred Switch Settings

	SW1	SW2	SW3	SW4	SW5	SW6	SW7	Jumper
ST1300	ON	OFF	OFF	OFF	OFF	OFF	ON	OPEN
ST1300 with Reservoir	ON	OFF	OFF	ON	OFF	OFF	ON	OPEN

Further Reading

• Installation Manual
• NM6R's installation instructions
• Installation on a ST1300
• STRider's installation: http://www.frontiernet.net/~st1300rider/05-16-05/ecc.htm
• ALANT's mounting bracket: stoler-bracket.doc (MS Word)
• Jefro's installation: http://www.st-owners.com/forums/showthread.php?t=22213
• Brave Salmon's right pod switches: http://www.st-owners.com/forums/showthread.php?t=18367

-- MarkFeit - 27 Apr 2008