ABS Computer Check Quick Guide

These procedures begin on page 18-5 of the service manual.

Tools and Supplies

Tools

• 5mm hex wrench or socket bit

Supplies

None needed.

Disassembly

Remove the rear and front seats.

Remove the left side cover.

Procedures

Fault Code Check

Turn the ignition switch OFF.

Remove the ABS motor fuses (H and M) from the FuseBlock and check their condition.

• The photo in the service manual describes these as the H and J fuses, but the wiring diagram shows them as the H and M fuses.

Turn the ignition switch ON.

Verify that the ABS indicator is lit.

Wait five seconds for the ABS indicator to go out.

Within three seconds, re-install the H fuse.

Up to two stored fault codes will be blinked out on the ABS indicator, each preceded by a long blink.

Turn the ignition switch OFF.

Fault Code Clear

Begin the Fault Code Check procedure above.

While the ABS indicator is blinking out the fault code, reinstall the M fuse.

Verify that the ABS indicator remains on after the fault codes are indicated.

Continue the procedure.

Reassembly

Install the M fuse.

Install the left side cover.

Install the front and rear seats.

Post-Service Checkout

None required.

-- MarkFeit - 21 Nov 2009